WANTED lathe

[Bendy]

Hi, I maybe interested in that, when you've finished it then I may contact you if I'm still looking
Thanks James

[audiobull]

I tell a lie it will not be "fully" restored as I have not had the bed reground but after measuring it was ok anyway. So it will not be "fully" restored money so to speak. All new gears, bolts, washers and more all direct from myford.
Will give you a shout. Keep an eye on here too for some good ones.
http://www.model-engineer.co.uk/

[island steamer]

An ML7 wont be any use for what you want to do. You would be better looking for a Colchester master or similar. I have turned a 19" fly wheel in a master and also board the cylinder block for a 4" engine so have a good look round and think about what you really need the machine to do.

[Bendy]

Ah right ok, I'll take that into consideration