Marshall Pump/Injector Elbow

[SteamingDan]

Has anybody got a pattern/casting for the flanged elbow that takes the injector steam pipe from the valve on the footplate through the side of the tender?

There should be an elbow inside the tender and outside the tender, sharing 4 bolts to clamp them together.

I understand this is also the same casting the bolts to the side of the tender that takes the pump delivery pipe forward to the clack.

TIA

Dan

[STERVAN]

I could do with one of those myself!.

[richbart01]

I am on the case of getting a pattern made - hands up - who wants a casting - let's get this moving .

[astrite 1921]

I have patterns for both pump and injector feeds. The pump one has a larger flange and the boss is also larger, tapped 1” BSP. The injector one has a smaller flange (relatively speaking), and a smaller boss which is tapped 3/4” BSP. I’ll look them out over the next week. Cheers, Neil. n.smith1@btinternet.com

[rs2000]

I need one too
I have a bare pump casing and nothing at all
Any help advice would be appreciated

[astrite 1921]

Originally Posted by richbart01

I am on the case of getting a pattern made - hands up - who wants a casting - let's get this moving .

PM Sent

[SteamingDan]

Neil Smith has kindly offered to cast me 2 flanged injector elbows. It is worth noting that the pump elbow is a different size to the injector elbow- thanks to Neil for highlighting this.

As a side note, I'm happy to machine a batch while I'm set up to do so if anyone else needs castings.

Dan

[8_10 Brass Cleaner]

In case those of you who don't speak 'Marshall' are confused, these photos might help.

[tenor]

Originally Posted by 8_10 Brass Cleaner

In case those of you who don't speak 'Marshall' are confused, these photos might help.

I don't, I was and they did. Thanks for posting. Looking at where the parts are they must take some hard knocks which probably accounts for their rarity.
Martin