Marshall Pump/Injector Elbow
 

Has anybody got a pattern/casting for the flanged elbow that takes the injector steam pipe from the valve on the footplate through the side of the tender?

There should be an elbow inside the tender and outside the tender, sharing 4 bolts to clamp them together.

I understand this is also the same casting the bolts to the side of the tender that takes the pump delivery pipe forward to the clack.

TIA

Dan

I could do with one of those myself!.

elbow
 

I am on the case of getting a pattern made - hands up - who wants a casting - let's get this moving .

Marshall Boiler Feed Elbows.
 

I have patterns for both pump and injector feeds. The pump one has a larger flange and the boss is also larger, tapped 1” BSP. The injector one has a smaller flange (relatively speaking), and a smaller boss which is tapped 3/4” BSP. I’ll look them out over the next week. Cheers, Neil. n.smith1@btinternet.com

I need one too
I have a bare pump casing and nothing at all
Any help advice would be appreciated