Feed Check Valve and Cock for Marshall Traction Engine

[wirro]

Hello,

to complete the restauration of my Marshall Light Traction Steam Engine I need some additional parts which have been stolen in the past. In particular I need a Feed Check Valve and Cock. If you think you may help me with this, then please send me a message, I also have drawings to help identify exactly what is needed.

Regards,

Tõnu O.

[astrite 1921]

Hello,
I may be able to help, if you give me your e-mail address I'll send some photos.
Regards,
Neil.

[wirro]

Hello,
My e-mail is wirro@hot.ee
Tõnu

[iain]

Dont think I'm being funny but you paid for the drawings to be copied and searched out from the hertitage centre for your use, not for public distribution. The Gainsborough hertitage centre makes very little money from them and all of it is put to continuing the drawings to be housed safely for future use.

I'm fully aware people will pass stuff around but on a public forum I dont think this is fair.

Just my opinion

[MartinP]

As has been mentioned in this thread, drawings that were commercially supplied, or are commercially available, should not be freely distributed on a public forum.

The message containing the drawings has been withdrawn to protect T-T from accusations of complicity in the distribution of potentially copyrighted material.

Martin

[The Rust Restorer]

Hi Tonu,
I have sent you 3 pictures of the clack valve / stop cock.
Cheers Robert