Free to a good home - 1st gear ring for a Burrell SCC
The gear is a 1st gear ring (69 teeth, 6DP, 20°PA) for a SCC Burrell, machined to the LSM drawings, with one small change. The 1/4" clearance mounting holes are actually 6mm. Naturally there's a catch! Due to a cockup on my part the casting slipped while cutting the gear teeth, so about 6 of the teeth are approximately 15thou thinner than they should be. It's not that obvious looking at it, but I decided to start again with a new casting.
The gear is free to a good home, collection from near Cambridge, or anywhere in the UK for the cost of postage. PM me for a picture. If it hasn't gone within the next few weeks it's going to be recycled!
Regards,
Andrew
|