Small milling machine wanted

[Ashley smith]

Well Iv finally got hold of a milling machine that suits my needs, next stage is some tooling, the spindle is mt3 I have got an er32 collet holder that has come with it that has a 3/8 drawbar, the first thing I will be after is a drill chuck, possible a full set of collets it should I just buy a selection? And obviously a few cutters, my question is where's best to buy from? Is a 3/8 draw bar common? Ideally I'm after a 3mt chuck that used a 3/8 drawbar so I don't have to keep changing it... Any suggestions welcome thanks again for all the replies
Ash


Sent from my iPhone using Tapatalk