Wanted so we can Convert a Roller

[HeritageSteam]

As some will know I look after the Vehicles at the Shuttleworth Collection at Old Warden. We have made a decision to actively now pursue the component parts to allow us to RE- convert our Clayton & Shuttleworth Traction Engine, 'Dorothy' back to her pre-preservation state as a 10 Ton Roller.


We have so far drawn a blank on trying to locate the original front rolls, which we understand were taken to be put to use as a cricket pitch roll. So we are looking to acquire a suitable set of front rolls and forks that would look more or less correct as a substitute. Aveling / Fowler would be acceptable. We will be casting a new C & S headstock.

Any leads would be grateful.

Stuart Gray 07785 258169

[Stephen/fish]

There was a set on Preston steam services

[Proff]

Duchy College in Stoke Climsland in Cornwall had a trailed roller made up of front rolls, Mr Wakeham might know who to contact.

[8_10 Brass Cleaner]

What are approximate sizes Stuart?

Diameter for similar engines?

Width between inside edges of rear wheels? (so the width of the front ones can be estimated).

I know of a good many sets of front rolls, which I can visit to gauge suitability with a tape. I don't buy them as they are essentially unsaleable in normal circumstances.

I assume Mr Haxby in Lincolnshire converted it before Garth Holman bought it?

[astrite 1921]

I assume Mr Haxby in Lincolnshire converted it before Garth Holman bought it?[/QUOTE]

No, I’ve seen a photo of it in Cornwall on wheels before Ray Haxby bought it in 1978. Incidentally, commercially he owned a very late Marshall 8NHP compound TE, 87512(1934).

[davidnclare]

It is nice to see this happening.

[weidner]

Then this might be the engine which I saw by the road in Fraddon in the '70's .

[Proff]

Originally Posted by weidner

Then this might be the engine which I saw by the road in Fraddon in the '70's .

That would have been George James Marshall conversion called ‘Fraddon’ Bob. If you travelled down further on the A30 just short of Chiverton you would have seen Solways Garage on your right, that’s where the Clayton was.

[1532]

There was a set of front rolls at Praze an Beeble park near Camborne not sure of make

[81119]

Originally Posted by 1532

There was a set of front rolls at Praze an Beeble park near Camborne not sure of make

The where for sale 3 year ago, when we came back through from WESES with 2 engines matey was trying to sale them to us whilst eating our chips.. said they had to go as he'd been instructed to buy an agricultural roller to use instead. Might pop round see if the are still sat in the field.