This is a a relatively small power pack - 2850 psi with a low flowrate. The gear pump is small - around 55mm square. I have no idea of the cc per rev. It used to run a vulcanising press. The press went a while ago after I advertised it on here (again free) but I kept the power pack for a job that never materialised. It was working fine when I got it and it has been dry stored.
I want it gone - either into the scrap bin or preferably into the car boot of the new owner.
It is too heavy/awkward to send so if you want it then you will have to collect it or arrange collection from Cardiff. I am prepared to keep it until the end of August and then it will be scrapped.
I doubt I will be going to GDSF so it is not an option for me to take it there.
It is 3 phase - see motor specs. It is a dual voltage motor so it could probably be run off of an inverter.
Cheers Carl.
