View Single Post
  #1  Post / In Thread 
Old 17th June 2016, 12:27 PM
Aveling8727's Avatar
Aveling8727 Aveling8727 is offline
Engineer
 
Full Name: G Townsend
Join Date: Dec 2011
Location: Southport
Posts: 1,034
Default Solid Oak Living Van Chassis Project

Selling my Living Van project due to losing storage and needing funds towards finishing the restoration of my Steam Roller. The chassis is all new Oak except for one of the small crossmembers you can see in the middle of the trailer that go side to side. It has had the Turntable Rebuilt , New Oak Beams on Axles. One axle is Braked. Needs one front and side beam to finish the chassis, the wood is there it just needs cutting and fitting. Needs the turntable pivots supports finishing and then it can be re-assembled. Roughly 13' long, 6' 6" wide. Was bought by me from Richard Gregory on here and I picked it up with a car trailer. Includes lots of Ironmongery such as handbrake mechanism, rear drawbar frame, chassis strengthening pieces etc. Would look very good finished, very traditional looking rather than building a van on an old Farm Trailer.

Located in Hesketh Bank Near Preston North West. Any question give me a ring on 07896514295. Open to offers.

Ive tried to take some pictures but they don't do it justice.





__________________


A ROLLER it was built, a ROLLER it will stay!

Aveling 8727 restoration thread
http://www.tractiontalkforum.com/showthread.php?t=26565
Reply With Quote