A set of unmachined castings and drawings for a 4 1/2 inch scale Burrell single cylinder traction engine. To Plastow design.
Set includes:
Flywheel
Cylinder
2 x rear hubs
RH crank bracket
LH Crank bracket
Steering and brake wheels
Clack valve body
Governor
Smokebox rings and cylinder plate
Final drive
Brake drum wheel
2nd shaft wheel
Wayshaft bracket
Pump
Perch bracket
Smoke box door
Spokes for front and rear wheels
Some other bits will be included, but I have not been able to ID them. I have only listed what I know to be present and recognise, but there are a couple of other brackets etc that probably belong with this. Basically what you see in the photos. I am selling on behalf of a friend.
Note that castings have been stored for many years and hence have surface rust, but are perfectly usable. As I say, unmachined, never been touched. Believed full set of drawings included.
I estimate this lot would cost 1900-2000 if bought now... Open to sensible offers, please message me.
