Elliott 00 omnimill in very good condition with all the bits for both verticle and horizontal milling has recently had a new major axis lead screw and nut. 3 phase machine (I can sell the inverter at additional cost) feeds all work well coolant pump all working. Fitted with digital scales on X and Y axis and dual metric imperial dials
Only a few minor bad points but I would rather be up front about them.
-chip out of edge of second drive pully
-Dual dials a bit sticky on the internal gears so I have removed the internal gear ring and currently use the digital read outs.
More info about these great little versitile machines available here
http://www.lathes.co.uk/elliottmillers/page2.html
Included in the sale will be a 4" machine vice horizontal arbor and spacers and a 3MT clarkson autolock I will offer the remaining 3MT tooling to the purchaser at additional cost.
Collection only but I can help load via Pallett truck or possible gantry
£1250 ONO or possible swap/PX for a good 6" ish centre height lathe.
Pictures available via email on request