Water Tenders
 

I have a couple of old water tenders that would suit a roller or tractor etc.

In need of restoration but a good basis to start and would really look the part as they are old and on cast wheels with steel frame (one is part wood) and a steel galvanised tank. A big old tap is situated at the rear to enable buckets to be filled or showers taken !!!

The size of the tank is approximately 30 inches X 54 inches and using the following formula = diameter and the height of the cylindrical tank in inches 3.14xDxDxH/6912 x 7.5I guestimate the capacity at 165 gallons or 750 litres.

Asking 250-00 each and planning to visit Somerset Steam do at Low Ham so can deliver them to site.

Will upload some photos later (after I have worked out how to) or pm an email address and I will forward on.

Hopefully this will work and there should be a picture of one of the bowsers http://my.picresize.com/98ETVI7QB9

If not apologies and back to the drawing board !!

Okey dokey hopefully this should work as followed the instructions to the T.

Picture of the other water tender.

Thanks for the interest shown in the bowsers; the one with the wooden/metal frame is now sold.