Quorn Easter Vintage Festival
 

Few pictures from the Quorn Easter Vintage Festival late on today. Unfortunately the light wasn't brilliant. The three Leicestershire rollers together for the first time in many years.

http://www.tractiontalkforum.com/pic...ictureid=29473

http://www.tractiontalkforum.com/pic...ictureid=29472

http://www.tractiontalkforum.com/pic...ictureid=29471

http://www.tractiontalkforum.com/pic...ictureid=29470

http://www.tractiontalkforum.com/pic...ictureid=29469

http://www.tractiontalkforum.com/pic...ictureid=29468

http://www.tractiontalkforum.com/pic...ictureid=29467

http://www.tractiontalkforum.com/pic...ictureid=29466

http://www.tractiontalkforum.com/pic...ictureid=29465

http://www.tractiontalkforum.com/pic...ictureid=29464

http://www.tractiontalkforum.com/pic...ictureid=29463

http://www.tractiontalkforum.com/pic...ictureid=29462

http://www.tractiontalkforum.com/pic...ictureid=29461

http://www.tractiontalkforum.com/pic...ictureid=29460

Fiery Elias is looking well.

Details of the early Aveling please.
Thanks Mike

I think it's Aveling 1760 of 1882 reg DP 3672. Other than that I don't know anything about it.

its the one that was with Jim crane and co aint it?

I also visited the GCR yesterday and this Aveling caught my eye – it has some unusual features compared to later machines. Below are three photos of it. Having recently drilled and tapped 16 holes to secure the cylinder on to the boiler barrel of my 3” Foden, I had to take a photo of the cylinder on this engine – I think it has 8 bolts holding the cylinder down. Can anyone enlighten me as to what is going on with the cylinder end cover – it seems to allow access to the end of the steam chest/valve...? What material would the boiler be made from – wrought iron or steel?

Michael

http://www.tractiontalkforum.com/pic...ictureid=29477

http://www.tractiontalkforum.com/pic...ictureid=29478

http://www.tractiontalkforum.com/pic...ictureid=29479

The cylinder bolts are to hold the casting in position - it is not a steam tight joint. There will be two pipes from the boiler providing the steam supply with nuts and joints accessed originally via the manhole in the front tubeplate - the standard arrangement for Aveling rollers and engines up to the turn of the century. The boiler would originally have been WI - whether it is now depends on whether it has been reboilered which it appears to have been given the manhole in the barrel. The cylinder cover is combined as two parts with a front cover to the valve chest - again standard for rollers and engines of that age.

Paul

The cylinder is known as a nipple cylinder as there are two large pipe nipples into the boiler barrel that seal the steam joint. The front of the valve chest area does come off I wonder if it was an aid to machining to face the valve on a slotter type machine.
I would guess by the position of the man hole it was reboilered by Avelings
Mine is number 2760 from 1890 and has the same features including being reboilered in 1912
Mike
Typing at the same time as Paul

The cylinder could be fed with steam by a nipple through the barrell shell so the base of the cylinder itself dos'nt need to be a steam tight joint. Though I.m not really up on Avelings , someone will correct me if i'm wrong. It could also be an elbow into the rear of the cyl, with the same effect. The boiler may well be steel.

Think it's still with Crane family.