Clarkson Mk1 Tool and Cutter Grinder - Unfinished Project
 

Clarkson Mk1 Tool and Cutter Grinder - Unfinished Project
I don't have the time to finish it.

What you see in the photos is all that is included.

Its been stripped down and cleaned, had a coat of paint.
The motor is 3phase, and has been tested and runs fine, it will run on single phase 240V if you use the correct capacitors to do the conversion. (I tested it on an inverter)
It requires a spindle nut, belt (there is a use one included), belt cover and new hight adjustment feed screw and nut, plus a nut to lock the hight adjustment.
There is some backlash in the feed screw, but ways are good.

It has been well used over the years but you can get many more years of use out of it once the few bits above have been made..

Collection from South London postcode

£250 ?

http://www.linefeed.com/142.JPG
http://www.linefeed.com/141.JPG
http://www.linefeed.com/139.JPG
http://www.linefeed.com/138.JPG