Line shaft parts
 

I'm looking for some line shaft parts please, open to anything but ideally for 1.3/16'' or 1.1/4'' diameter shaft. Bearing blocks, pulleys, brackets etc.
Thanks.

I might know of some as some guy was supposed to pop round me house with photo's but he never showed up.
If he does I will see if I can pass the pictures on to you.

I did a job at an old mill, they ripped it all out I offered to buy but the bean counters dictated that its value of scrap was somewhere in a spreadsheet. Criminal!!!!

I've a pile here, but you'd have to shift and assemble it....

Farm local to me has a load in, you'd be more than welcome to it for a small fee I recon, but again you'd need to remove it yourself..

sent a pm

I find the organisers are only in it for their own ends. I know several traders who will not go to exhibitions because of the overhaul expense that they incur. We have to remember that the a certain organiser over the years has made several million pounds out of our hobby and bought himself a very nice farm and buildings that he uses as an exhibition centre. Never gives much back into the hobby though. What do you get for putting a model in one of his exhibitions, not a lot just one, one day free pass to get in with and no travelling expenses to transport your model to and from the exhibition. They also rip the hobbyist off with espensive addmission charges.

The exhibitions in Germany and Italy look after you far better with a pass for the whole of the exhibition, discount drink and food and a nice memento for exhibiting. I have said for a long time that our organisors should take note, but the refuse to listen.

Regards,
Roger G.

Nice rant, wrong thread ;)

Thanks guys, planning on coming over to the 'big island' this saturday heading toward chelmsford so available to rummage through some yards if needs be!