Aveling C/D type rims
 

I have an odd pair of 8 ton bolt-on rims for sale that came in the pile of bits - the type that were jig drilled for the hub spiders.

Rim 1: 57" OD by 18 3/4" wide, 49 1/4"ish PCD for spoke bolts, machined mating face of spoke ring is 7" in from inside edge.

Rim 2: 58" OD tapering out to 59", 17" wide with same PCD as above, machined face of spoke ring is 7 1/4" from inside edge.

Weight approximately 1 ton each. I think they are steel not cast iron.

There are a couple of smaller built up repairs from damage but no visible cracks. Surplus to requirements and causing trip hazard, fork lift available, located 1 minute off A31 Ringwood.

Offers above scrap value otherwise that's where they're going - so, if you have a mate in need of 1 and you're on the way to GDSF with the wagon - put the word out. Will split.

07786 565 323 John