Engine castings wanted
 

Hi,

I'm looking at starting a 3 or preferably 4" traction engine build shortly. Someone suggested I might try to obtain a 'part finished' project as some parts would already be completed which might speed the build process along a bit! Looking at perhaps a Foster or Burrell, any ideas/ prospective sellers?

Regards, Martin.


Sent from my iPad using Tapatalk HD

hi martin your looking for castings i may be able to help castingman

What have you got castingman?


Sent from my iPad using Tapatalk HD

4.5in Burrell Castings.
 

Hi Martin,

I have a pile of castings and finished parts for a 4.5 in scale Burrell project that will not now be completed by myself. A lot of the parts are Plastow and are good quality. Much of the front end is built including finished and rubberred front wheels, the pump is machined as are rear wheel hubs etc. Much is done, full set of drawings, but no boiler.

Email me or PM if its of interest; piecrusty@ntlworld.com

Best Regards,
Mark Pybus, Im near Manchester by the way!thumbsup

castings
 

I have casting for 1 engine and part built 4 in ruston email for detail

.com

Brian/Mark... did you do s deal? Im after castings/parts for a 4 inch engine...

basically nothing but if you have patterns I can make the castings also if you need patts made I can get them done for you thanks:)