aveling fire hole door
Need a new firehole door for our e-type.
Anyone git one or pattern we could borrow to get one cast please? |
What size is it. May have a pattern.
Sent from my iPhone using Tapatalk |
Quote:
Will have a measure up later this week Sent from my iPhone using Tapatalk |
Looking for a 10 3/4" diameter door
https://uploads.tapatalk-cdn.com/201...87813ff65a.jpg Sent from my iPhone using Tapatalk |
Thanks, I think ours is for a 10x9 hole, so may not work. Will go up the yard in the morning and have a measure. It might work as you have a flat bit. I try to post a picky.
Cheers Douglas |
Ok thanks
Sent from my iPhone using Tapatalk |
That one you got for John Ralphs was ok. Is there much difference in size?
|
Yes Jim, quite different shape, for an oval door. Also it was a spare casting I had, but it was not my pattern it was from.
Sent from my iPhone using Tapatalk |
Firedoor
Hello been a while since I was last on this site just wondering if you managed to get a pattern and where do you normally source your castings from since I have a small ferrous and non ferrous foundry situated just out side Stourbridge in the West Midlands maybe you would like to send me amessage thank your
|
Did you manage to get one, Stuart?
I could do with one now! |
Quote:
Borrowed a spare door but didn’t get on very well at the foundry. Have resorted to a fabrication Sent from my iPhone using Tapatalk |
All times are GMT. The time now is 02:39 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.