Check out:-

http://www.allsteelstrading.co.uk/EN...l-convex-flats

See form on the left "Convex feather edge".

Cheers Carl.

Hi
Thanks for the lead but sadly this is the same as what my normal steel stockist has offered me what I need is a full half round
Chris

Hi Chris

Sorry, that was wholly my misunderstanding.

Cheers Carl.

Hi
There seems to be some confusion as to whether I need 1 inch or 1 1/8" half round could another Marshall owner measure the half round on their spud pan for me please thanks Quest

This photo was taken when I was commissioned to paint a picture of the engine by the owner at the time.

The beading can be seen clearly. I imagine a fair amount of work in building a brand new spud pan like this.

Michael

http://www.tractiontalkforum.com/pic...ictureid=51868

1" x 1/2" true half round steel section
 

http://www.tractiontalkforum.com/pic...ictureid=44044

This is the section I used when I did my spud pan - I have four 12 ft lengths in stock which is plenty for two pans but not enough for three. Just checking to see if there is any more hidden away anywhere.

Try F.H. brundle. They do 30mm convex feather edge.

Hi
Have PM you
Chris