Gear cutter 7/8” CP

[RWHB1]

Anyone got the above for a reasonable price? 1” bore.

Russ

[carl_byrne]

I think I have a few 7/8" CP cutters - how many teeth are you planning to cut? I would not want to sell one but I would be happy to loan it if you covered the cost of regrinding it if this was required after you have finished with it.
It's a fairly large tooth - approximately 3.5 DP.

Cheers Carl

[RWHB1]

Thanks for the reply Carl. 44 teeth 0.6007” & 1/64th thin according to the Foden drawing. I also want to cut a new speedo gear, but have to dig the old one out, maybe 12 teeth. No problem paying for grinding and carriage. 1” bore?

Russ

[carl_byrne]

Russ

I will dig out my gear cutters and check what I have.

Cheers Carl.

[carl_byrne]

Hi Russ

PM sent.

Cheers Carl.