Anvil
Blacksmiths anvil,just over one cwt,length from beak to back is 23 inches,this anvil is in 1st class condition ,virtually no use ,the top surface is true and flat with no knocks or dents on the edges,there is some faint letter stamping on the side which appears to be the makers name P Wright. price £250
Bench shears, name plate states "handy shearing machine" capacity 1/4 plate,5/16 by 1 1/2 inch bar, 3/8 round or square .the shear blades about 6 inches cutting length,are in good condition,the maximum capacity is perhaps a bit optimistic, most of my cutting was 3 and 4mm strip, no longer required as I now have a bandsaw £35
large and heavy Record no 25 bench vice with quick release mechanism, 6 inch wide jaws,used but works ok, the corner of the casting supporting the fixed jaw is damaged ,I can email a photo, £30
all being sold as I am downsizing my workshop as at some time in the future I will have to move to a smaller home.
Buyers must collect,located 6 miles to the west of Petersfield Hampshire
|
16th February 2017, 11:56 AM
Linear Mode
