Swift Lathe with lots of tooling

[Allan J]

Stats:-

33" swing over gap
23" swing over bed
68" between centres
Overall height 56"
Length 137"
Width 55"
Motor 7 1/2 hp Metropolitan Vickers 3 ph.
20" 4 jaw chuck
12" 3 jaw chuck
10" 3 jaw chuck
33" faceplate
20" faceplate
11" drive plate
Various drive dogs
Full set change gears
Large quantity of tooling inc. custom made tools + optional extras ( e.g. boring & facing head )

This is a vintage lathe that has done very little work in it's long life due to the fact that it was installed in the maintainance dept of a cigarette factory (the Wills factory on Newcastle's coast road) Where there was another smaller lathe installed also.
Since the factory closure this machine has done 3 years light occasional work in my small workshop, the lack of wear to the bed and slide ways has to be seen to be believed.

Guide price £2,500 negotiable.

If you need a good sized lathe you must see this one, contact Allan on 01665 713296