3" scale Yorkshire wg steam wagon
3” scale Yorkshire WG Steam Wagon
Part built by me but has not been touched for many years
Size of wagon is 49” long x 22” wide x 20” tall
Boiler is steel made by Franklin & Bell in march 2000
Test Pressure ; 300 psi
Working Pressure : 150 psi
It comes with all the original paper work which includes plate certificates & original boiler test certificate
This to made to a bigger size of the suffolk dredging tractor design , 7 1/2” dia x 17” long , Grate area 5 1/2” sq
Included are the following castings to build the twin cylinder engine
Cylinder part machined - cast iron
Cast iron piston rings
2 off trunk guide castings - cast iron
2 off cylinder covers - cast iron
2 off cylinder valve chest castings - cast iron
2 off slide valve castings - gunmetal
2 off slide valve buckles - gunmetal
Chimney top - brass casting
1 off flywheel casting - 5 3/8” dia x 1 1/8” wide - cast iron
Fabricated steel crankcase with fabricated steel sump
I have done a lot of sketch’s of the engine parts which were taken from an engine that was on the rally fields many years ago with also a good few photo’s of the finished engine
photo's are available for this engine please enquire
Visitors welcome to inspect this engine
07971 332245
£1250 .00 ono
|